Cedar Hills · Same-day
Boiler Flame Failure in Cedar Hills
The burner lights then loses flame within seconds and locks out. This page covers how we diagnose and repair it on boilers in Cedar Hills.
This fault is normally treated as same-day work because the site has effectively lost hot water, steam or safe operation.
Cedar Hills sits within the Fourways belt, with larger stands, long hot water runs and frequent pool heating. Static pressure and dead-leg length are checked as part of any hot water complaint here. Where a site runs on borehole water, hardness and iron content shorten service intervals considerably and are worth testing before setting a maintenance plan.
- Area
- Cedar Hills, Johannesburg
- Equipment
- Boilers
- Call
- 069 268 0988
What we find here
Likely causes
- Dirty or cracked flame rod
- Failed UV scanner
- Poor earth on the flame sensing circuit
- Incorrect air/fuel ratio
- Fluctuating gas supply pressure
How it is confirmed
Diagnostic sequence
- Flame signal measurement in microamps
- Earth continuity test
- Combustion analysis through the firing range
- Gas pressure under load
Repair route
Repair services in Cedar Hills
Boiler Repairs Cedar Hills
Repairs to gas, diesel, electric and steam boilers across Gauteng.
Boiler Maintenance Cedar Hills
Planned boiler servicing, combustion tuning and safety device testing.
Gas Boiler Repairs Cedar Hills
Natural gas and LPG boiler repairs, ignition and flame failure faults.
Industrial Boiler Repairs Cedar Hills
Heavy-duty boiler plant repairs for factories and processing sites.
Coverage
Nearby areas
- Boiler Flame Failure Steyn City
- Boiler Flame Failure Kengies
- Boiler Flame Failure Norscot
- Boiler Flame Failure Norscot Slopes
- Boiler Flame Failure Douglasdale Ext
- Boiler Flame Failure Magaliessig
- Boiler Flame Failure Magaliessig Ext
- Boiler Flame Failure Paulshof
- Boiler Flame Failure Paulshof Ext
- Boiler Flame Failure Fourways
FAQs
Frequently asked questions
What causes boiler flame failure?
The usual causes are dirty or cracked flame rod, failed uv scanner, poor earth on the flame sensing circuit, incorrect air/fuel ratio. Which one it is can only be confirmed by measurement, not by symptom alone.
How do you diagnose it?
Flame signal measurement in microamps; Earth continuity test; Combustion analysis through the firing range; Gas pressure under load. The readings are recorded so the repair decision is based on data.
Can I keep using the system in the meantime?
No — isolate the plant and call 069 268 0988. Running it in this condition risks further damage or an unsafe situation.
Do you attend this fault in Cedar Hills?
Yes. Technicians work out of the central Johannesburg base, which keeps travel time short for northern-suburb call-outs. Cedar Hills visits carry heat pump and geyser spares together, since both are commonly installed on the same property.
Boiler Flame Failure — Cedar Hills
Cedar Hills visits carry heat pump and geyser spares together, since both are commonly installed on the same property.