Hot water systems · Same-day

Hot Water Geyser Not Heating

No hot water at the taps although the geyser has power and water.

This fault is normally treated as same-day work because the site has effectively lost hot water, steam or safe operation.

Where a site runs on borehole water, hardness and iron content shorten service intervals considerably and are worth testing before setting a maintenance plan.

069 268 0988 info@reyds.co.za

Equipment: Hot water systems
Priority: Same-day
Call: 069 268 0988

What we find

Likely causes

Burnt-out element
Failed thermostat
Tripped thermal cut-out
Isolator or wiring fault
Scaled element unable to transfer heat

Test sequence

How we diagnose it

Element resistance and insulation test
Thermostat continuity test
Supply voltage check at the geyser
Visual scale inspection on removal

Repair route

Services that resolve this fault

Hot Water Geyser Repairs

Element, thermostat, valve and leak repairs on electric geysers.

5 000 Litre Hot Water Geyser Repairs

Large-volume storage geyser repairs, elements, thermostats and stratification.

Industrial Hot Water Systems

Design, repair and optimisation of bulk hot water plant.

Calorifier Repairs

Steam and hot water calorifier coil, control valve and tank repairs.

Hot Water Storage Tank Maintenance

Descaling, anode replacement and integrity checks on storage vessels.

Emergency Breakdown Service

Priority attendance for total hot water or steam loss.

Coverage

Attendance by area

Also check

Related faults

5 000 Litre Geyser Not Heating

A large storage geyser is not reaching temperature or recovers far too slowly.

Commercial Hot Water System Failure

The site loses hot water during peak periods while plant appears to be running.

Low or No Hot Water Pressure

Hot water pressure is much weaker than cold, or fluctuates at the outlet.

Calorifier Not Heating

The calorifier receives steam or hot water but the stored water stays cold.

FAQs

Frequently asked questions

What causes hot water geyser not heating?

The usual causes are burnt-out element, failed thermostat, tripped thermal cut-out, isolator or wiring fault. Which one it is can only be confirmed by measurement, not by symptom alone.

How do you diagnose it?

Element resistance and insulation test; Thermostat continuity test; Supply voltage check at the geyser; Visual scale inspection on removal. The readings are recorded so the repair decision is based on data.

Can I keep using the system in the meantime?

No — isolate the plant and call 069 268 0988. Running it in this condition risks further damage or an unsafe situation.

Where do you attend this fault?

Across Johannesburg, Ekurhuleni, West Rand, Midrand, Centurion and Pretoria.

Get hot water geyser not heating diagnosed

Same-day attendance across Johannesburg, Ekurhuleni, West Rand, Midrand, Centurion and Pretoria.

069 268 0988 Request a quote