Reyds.Heat pumps · Boilers · Steam

Sebokeng · Same-day attendance

Ice Machine Overflowing in Sebokeng

Ice Machine Overflowing in Sebokeng, Johannesburg. Water overflows the sump or bin during operation.

Urgency for this fault is normally same-day. Call-outs are run from the central Johannesburg base, which keeps attendance windows short for kitchens in the northern and central suburbs.

The ice plant here is mostly estate clubhouses, guest houses, small restaurants and private bars, so the work is weighted towards undercounter and small modular machines. Water in this part of Gauteng is moderately hard, so scale on evaporator plates, spray bars and float valves is the single most common reason output drifts below the plate rating.

We diagnose in order of likelihood rather than replacing parts speculatively: test inlet valve shut-off with power removed, then clean and test float or probe, then clear overflow and drain lines.

Area
Sebokeng, Johannesburg
Urgency
Same-day
Call
069 268 0988

What we check first

Likely causes

  • Inlet valve not closing
  • Float or level probe scaled or stuck
  • Blocked overflow or drain
  • Incorrect water pressure to the machine
  • Failed level control board

How it is tested

Diagnostic sequence

  • Test inlet valve shut-off with power removed
  • Clean and test float or probe
  • Clear overflow and drain lines
  • Measure supply pressure
  • Check level control output

FAQs

Frequently asked questions

What causes ice machine overflowing?

The usual causes are inlet valve not closing, float or level probe scaled or stuck, blocked overflow or drain, incorrect water pressure to the machine. Which one applies is settled on site by measurement, not guesswork.

How quickly can you attend in Sebokeng?

Same-day attendance applies to this fault. Call-outs are run from the central Johannesburg base, which keeps attendance windows short for kitchens in the northern and central suburbs. Call 069 268 0988 for the next available slot.

How is it diagnosed?

Test inlet valve shut-off with power removed; Clean and test float or probe; Clear overflow and drain lines; Measure supply pressure; Check level control output.

Is this common on block ice machines?

Block plant is the slowest ice to make and the slowest to melt, which is why it survives in transport and fishing duty. On block ice machines in Sebokeng we see this fault regularly, usually alongside overdue descaling.

Which service will fix it?

Ice Machine Installation normally resolves it. Typically one day for self-contained and modular plant; two to three with a remote condenser.

Can we keep operating in the meantime?

Sometimes — where the fault is a water-side problem the machine can often be run on reduced output until parts arrive. Where a compressor or leak is involved we advise buying in bagged ice while the repair is completed.

Ice Machine Overflowing in Sebokeng

Community facility hot water plant supported.