Reyds.Heat pumps · Boilers · Steam

Mondeor · Same-day attendance

Ice Machine Freezing Up in Mondeor

Ice Machine Freezing Up in Mondeor, East Rand. Ice builds on the suction line, plate or in the bin, jamming the machine.

Urgency for this fault is normally same-day. Ekurhuleni visits are grouped by area so restaurant and factory ice plant can be attended on the same run.

The ice plant here is mostly estate clubhouses, guest houses, small restaurants and private bars, so the work is weighted towards undercounter and small modular machines. Filtration sized on measured hardness and throughput is the cheapest protection available for an ice machine's water circuit and pump.

We diagnose in order of likelihood rather than replacing parts speculatively: observe a full freeze and harvest cycle, then test bin level control interruption, then check curtain and chute clearance.

Area
Mondeor, East Rand
Urgency
Same-day
Call
069 268 0988

What we check first

Likely causes

  • Failed harvest cycle leaving the plate frozen
  • Bin level control not stopping production
  • Curtain or chute obstruction
  • Low charge causing partial plate freezing
  • Bin door left open melting and refreezing ice

How it is tested

Diagnostic sequence

  • Observe a full freeze and harvest cycle
  • Test bin level control interruption
  • Check curtain and chute clearance
  • Read superheat and suction pressure
  • Inspect bin gasket and door closure

FAQs

Frequently asked questions

What causes ice machine freezing up?

The usual causes are failed harvest cycle leaving the plate frozen, bin level control not stopping production, curtain or chute obstruction, low charge causing partial plate freezing. Which one applies is settled on site by measurement, not guesswork.

How quickly can you attend in Mondeor?

Same-day attendance applies to this fault. Ekurhuleni visits are grouped by area so restaurant and factory ice plant can be attended on the same run. Call 069 268 0988 for the next available slot.

How is it diagnosed?

Observe a full freeze and harvest cycle; Test bin level control interruption; Check curtain and chute clearance; Read superheat and suction pressure; Inspect bin gasket and door closure.

Is this common on cube ice machines?

Cube clarity is the fastest indicator of scale: cloudy, hollow cubes mean the water circuit needs descaling before anything else is investigated. On cube ice machines in Mondeor we see this fault regularly, usually alongside overdue descaling.

Which service will fix it?

Ice Machine Installation normally resolves it. Typically one day for self-contained and modular plant; two to three with a remote condenser.

Can we keep operating in the meantime?

Sometimes — where the fault is a water-side problem the machine can often be run on reduced output until parts arrive. Where a compressor or leak is involved we advise buying in bagged ice while the repair is completed.

Ice Machine Freezing Up in Mondeor

Mondeor falls inside our core northern-suburb route, so response is normally same-day for loss-of-hot-water call-outs.