Reyds.Heat pumps · Boilers · Steam

Greenstone · Same-day attendance

Ice Machine Overflowing in Greenstone

Ice Machine Overflowing in Greenstone, East Rand. Water overflows the sump or bin during operation.

Urgency for this fault is normally same-day. Ekurhuleni visits are grouped by area so restaurant and factory ice plant can be attended on the same run.

The installed base here is hospitality and retail: bar and restaurant cube machines, hotel modular plant on bins, and flake machines behind fish and meat counters. Filtration sized on measured hardness and throughput is the cheapest protection available for an ice machine's water circuit and pump.

We diagnose in order of likelihood rather than replacing parts speculatively: test inlet valve shut-off with power removed, then clean and test float or probe, then clear overflow and drain lines.

Area
Greenstone, East Rand
Urgency
Same-day
Call
069 268 0988

What we check first

Likely causes

  • Inlet valve not closing
  • Float or level probe scaled or stuck
  • Blocked overflow or drain
  • Incorrect water pressure to the machine
  • Failed level control board

How it is tested

Diagnostic sequence

  • Test inlet valve shut-off with power removed
  • Clean and test float or probe
  • Clear overflow and drain lines
  • Measure supply pressure
  • Check level control output

FAQs

Frequently asked questions

What causes ice machine overflowing?

The usual causes are inlet valve not closing, float or level probe scaled or stuck, blocked overflow or drain, incorrect water pressure to the machine. Which one applies is settled on site by measurement, not guesswork.

How quickly can you attend in Greenstone?

Same-day attendance applies to this fault. Ekurhuleni visits are grouped by area so restaurant and factory ice plant can be attended on the same run. Call 069 268 0988 for the next available slot.

How is it diagnosed?

Test inlet valve shut-off with power removed; Clean and test float or probe; Clear overflow and drain lines; Measure supply pressure; Check level control output.

Is this common on flake ice machines?

Flake plant fails mechanically more often than refrigeration-wise: water seals, bearings and gearboxes are the parts that decide machine life. On flake ice machines in Greenstone we see this fault regularly, usually alongside overdue descaling.

Which service will fix it?

Ice Machine Servicing normally resolves it. Half a day per machine, including refill and a full production cycle.

Can we keep operating in the meantime?

Sometimes — where the fault is a water-side problem the machine can often be run on reduced output until parts arrive. Where a compressor or leak is involved we advise buying in bagged ice while the repair is completed.

Ice Machine Overflowing in Greenstone

Medical facility hot water compliance checks available.