Reyds.Heat pumps · Boilers · Steam

Irene · Same-day attendance

Ice Machine Overflowing in Irene

Ice Machine Overflowing in Irene, Midrand & Centurion. Water overflows the sump or bin during operation.

Urgency for this fault is normally same-day. Midrand and Centurion sit on the route between the Johannesburg and Pretoria runs, so attendance windows here are usually the shortest available.

The installed base here runs from single undercounter bar machines through to modular hotel plant and flake counters, so the first job is establishing exactly what is installed and how hard it is worked. Water in this part of Gauteng is moderately hard, so scale on evaporator plates, spray bars and float valves is the single most common reason output drifts below the plate rating.

We diagnose in order of likelihood rather than replacing parts speculatively: test inlet valve shut-off with power removed, then clean and test float or probe, then clear overflow and drain lines.

Area
Irene, Midrand & Centurion
Urgency
Same-day
Call
069 268 0988

What we check first

Likely causes

  • Inlet valve not closing
  • Float or level probe scaled or stuck
  • Blocked overflow or drain
  • Incorrect water pressure to the machine
  • Failed level control board

How it is tested

Diagnostic sequence

  • Test inlet valve shut-off with power removed
  • Clean and test float or probe
  • Clear overflow and drain lines
  • Measure supply pressure
  • Check level control output

FAQs

Frequently asked questions

What causes ice machine overflowing?

The usual causes are inlet valve not closing, float or level probe scaled or stuck, blocked overflow or drain, incorrect water pressure to the machine. Which one applies is settled on site by measurement, not guesswork.

How quickly can you attend in Irene?

Same-day attendance applies to this fault. Midrand and Centurion sit on the route between the Johannesburg and Pretoria runs, so attendance windows here are usually the shortest available. Call 069 268 0988 for the next available slot.

How is it diagnosed?

Test inlet valve shut-off with power removed; Clean and test float or probe; Clear overflow and drain lines; Measure supply pressure; Check level control output.

Is this common on water-cooled ice machines?

Water-cooled plant hides high head pressure until the condenser scales up, at which point output collapses quickly. On water-cooled ice machines in Irene we see this fault regularly, usually alongside overdue descaling.

Which service will fix it?

Ice Machine Replacement normally resolves it. One to three days depending on access and configuration.

Can we keep operating in the meantime?

Sometimes — where the fault is a water-side problem the machine can often be run on reduced output until parts arrive. Where a compressor or leak is involved we advise buying in bagged ice while the repair is completed.

Ice Machine Overflowing in Irene

Gas boiler servicing and heat pump maintenance often combined in one visit.