Reyds.Heat pumps · Boilers · Steam

Benoni · Scheduled attendance

Ice Melting in the Bin in Benoni

Ice Melting in the Bin in Benoni, East Rand. Stored ice melts away between services or fuses into a block.

Urgency for this fault is normally scheduled. Ekurhuleni visits are grouped by area so restaurant and factory ice plant can be attended on the same run.

The installed base here runs from single undercounter bar machines through to modular hotel plant and flake counters, so the first job is establishing exactly what is installed and how hard it is worked. Filtration sized on measured hardness and throughput is the cheapest protection available for an ice machine's water circuit and pump.

We diagnose in order of likelihood rather than replacing parts speculatively: inspect gasket and door alignment, then check panel for water logging, then clear and trap the bin drain.

Area
Benoni, East Rand
Urgency
Scheduled
Call
069 268 0988

What we check first

Likely causes

  • Perished bin gasket or misaligned door
  • Failed bin insulation or water-logged panel
  • Blocked bin drain leaving meltwater in contact with ice
  • Bin sited next to a heat source
  • Ambient too high for uninsulated storage

How it is tested

Diagnostic sequence

  • Inspect gasket and door alignment
  • Check panel for water logging
  • Clear and trap the bin drain
  • Measure bin and ambient temperatures
  • Review siting and heat sources

FAQs

Frequently asked questions

What causes ice melting in the bin?

The usual causes are perished bin gasket or misaligned door, failed bin insulation or water-logged panel, blocked bin drain leaving meltwater in contact with ice, bin sited next to a heat source. Which one applies is settled on site by measurement, not guesswork.

How quickly can you attend in Benoni?

Scheduled attendance applies to this fault. Ekurhuleni visits are grouped by area so restaurant and factory ice plant can be attended on the same run. Call 069 268 0988 for the next available slot.

How is it diagnosed?

Inspect gasket and door alignment; Check panel for water logging; Clear and trap the bin drain; Measure bin and ambient temperatures; Review siting and heat sources.

Is this common on flake ice machines?

Flake plant fails mechanically more often than refrigeration-wise: water seals, bearings and gearboxes are the parts that decide machine life. On flake ice machines in Benoni we see this fault regularly, usually alongside overdue descaling.

Which service will fix it?

Ice Machine Maintenance Contracts normally resolves it. Standard visits are two to four hours per machine on a fixed schedule.

Can we keep operating in the meantime?

Sometimes — where the fault is a water-side problem the machine can often be run on reduced output until parts arrive. Where a compressor or leak is involved we advise buying in bagged ice while the repair is completed.

Ice Melting in the Bin in Benoni

School and hostel plant serviced during term breaks where possible.