Reyds.Heat pumps · Boilers · Steam

Benoni · Same-day attendance

Ice Machine Overflowing in Benoni

Ice Machine Overflowing in Benoni, East Rand. Water overflows the sump or bin during operation.

Urgency for this fault is normally same-day. Ekurhuleni visits are grouped by area so restaurant and factory ice plant can be attended on the same run.

The installed base here runs from single undercounter bar machines through to modular hotel plant and flake counters, so the first job is establishing exactly what is installed and how hard it is worked. Water in this part of Gauteng is moderately hard, so scale on evaporator plates, spray bars and float valves is the single most common reason output drifts below the plate rating.

We diagnose in order of likelihood rather than replacing parts speculatively: test inlet valve shut-off with power removed, then clean and test float or probe, then clear overflow and drain lines.

Area
Benoni, East Rand
Urgency
Same-day
Call
069 268 0988

What we check first

Likely causes

  • Inlet valve not closing
  • Float or level probe scaled or stuck
  • Blocked overflow or drain
  • Incorrect water pressure to the machine
  • Failed level control board

How it is tested

Diagnostic sequence

  • Test inlet valve shut-off with power removed
  • Clean and test float or probe
  • Clear overflow and drain lines
  • Measure supply pressure
  • Check level control output

FAQs

Frequently asked questions

What causes ice machine overflowing?

The usual causes are inlet valve not closing, float or level probe scaled or stuck, blocked overflow or drain, incorrect water pressure to the machine. Which one applies is settled on site by measurement, not guesswork.

How quickly can you attend in Benoni?

Same-day attendance applies to this fault. Ekurhuleni visits are grouped by area so restaurant and factory ice plant can be attended on the same run. Call 069 268 0988 for the next available slot.

How is it diagnosed?

Test inlet valve shut-off with power removed; Clean and test float or probe; Clear overflow and drain lines; Measure supply pressure; Check level control output.

Is this common on undercounter ice machines?

The most common fault on undercounter machines is not a fault at all: enclosed cabinetry starving the condenser of air. On undercounter ice machines in Benoni we see this fault regularly, usually alongside overdue descaling.

Which service will fix it?

Ice Machine Maintenance Contracts normally resolves it. Standard visits are two to four hours per machine on a fixed schedule.

Can we keep operating in the meantime?

Sometimes — where the fault is a water-side problem the machine can often be run on reduced output until parts arrive. Where a compressor or leak is involved we advise buying in bagged ice while the repair is completed.

Ice Machine Overflowing in Benoni

School and hostel plant serviced during term breaks where possible.